Alloy section used to house handbrake and gear shift assembly, cables atttached but layed onto to measure up!


Cut outs done for mounting cables through


Working version of the selector mechanism bare


Mechanism with push rods and cranks fitted (extended threaded rod to be swapped out)


Fitted in position at the back of the buggy! (Again the extended threaded rod is to be swapped out with correct length bolts)




A lot of work went into getting this correct, it was surprising just how much work was needed just to find out how big the cross gate crank needed to be! Anyway it works like a dream now, just enough movement across the gate and a good notchy click as it goes into each gear, overall I'm very happy