Well been busy doing loads of stuff on the buggy, bot the cooling system plumbed in and the ECU fully remapped with all the crap removed!!
3d printed a new MAF adaptor with a 15 degree bend in it (Old and new below)
Did all the intercooler plumbing;
Plumbed the radiator;
plumbed the oil evap system with a small catch tank;
Stripped cleaned and serviced the injector rail (new seals on all injectors cleaned etc ) then swapped the 3bar fuel regulator for a bosch 4bar regulator (ECU is mapped to a 4Bar regulator now)
And this is what she looks like now ;D ;D
I've just finished 3d printing the ECU mount that goes on one of the old firewall sections behind the seats, high up out of the way!!, just prepping the looms to go back on the engine so i can get all the clips measured up and fitted - and slowly getting the AN10 oil fittings so i can do the oil pipework and fuel pipework.
3d printed a new MAF adaptor with a 15 degree bend in it (Old and new below)
Did all the intercooler plumbing;
Plumbed the radiator;
plumbed the oil evap system with a small catch tank;
Stripped cleaned and serviced the injector rail (new seals on all injectors cleaned etc ) then swapped the 3bar fuel regulator for a bosch 4bar regulator (ECU is mapped to a 4Bar regulator now)
And this is what she looks like now ;D ;D
I've just finished 3d printing the ECU mount that goes on one of the old firewall sections behind the seats, high up out of the way!!, just prepping the looms to go back on the engine so i can get all the clips measured up and fitted - and slowly getting the AN10 oil fittings so i can do the oil pipework and fuel pipework.