Well been working on the buggy engine mount design again, built a dummy engine model to get it roughly correct then fine tune it later this is the back of the buggy with the rear frame removed:


The plates under the engine are placeholders for the final water cut parts that will make up the engine sub-frame - still working on it but should get more done this week as im on holiday now till the new year!

Oh and Father Christmas popped round with a few shiny bits (new intercooler and a remote oil filter mounting and sandwich plate, with a re-usable oil filter)



Intercooler is a toyosport with a 2.5" inlet and outlet



anyway got to try and get the sub frame design finished then I can get it off to the local laser cutting company